Amazon Sr Hardware Dev Engineer Project Kuiper 

United States, Washington, Redmond 

448581063

As a Sr. Hardware Development Engineer (HDE), you will engage with an experienced cross-disciplinary team to conceive and design innovative product solutions. You will work closely with colleagues throughout Project Kuiper’s inter-disciplinary team to design and deliver hardware for the payload. You must be responsive, flexible and able to succeed within a collaborative and fast-paced environment.Export Control Requirement:
Key job responsibilities
As a Senior HDE, you will be a part of the team of experts working on the development of advanced electronic products. You will own or contribute to the following:
• Design digital and analog and/or RF circuits in collaboration with various teams
• Design and optimization of different blocks of electronics sub-systems.
• Design for high speed and FPGA circuitry.
• Optimize board design for high-speed clocks, transmission lines and their terminations.
• Design and optimization of different blocks of electronics sub-systems.
• Perform schematic capture and lead PCB layout implementation.
• Work with software teams to determine requirements for FPGA and processor designs.
• Bring up Linux on embedded systems.
• Support flow-down requirement definitions and generate test plans/procedures
• Board bring-up and perform test campaigns of modules and subsystems
• Support design automated test systems, test fixtures and factory test
• Work in the lab environment with various equipment like Oscilloscopes, Spectrum Analyzers, Logic Analyzers, Network Analyzers, etc.
A day in the life
As a Sr. HDE, you will work in a multi-disciplinary environment to design and deliver hardware for space. This requires the ability to work from concept to production. Candidates must be comfortable to work in the lab to debug and verify their designs.

- BS degree in electrical engineering or computer engineering, or equivalent experience · 5+ years of experience in hardware development across full product life cycle.
- 3+ years of experience in using schematic capture tool and PCB layout viewer
- 3+ years of experience board bring up and debugging in lab environment
- 3+ years of experience using lab equipment including soldering irons, hand-tools, oscilloscopes, logic analyzers, and spectrum analyzers

- Masters of Science or PhD in electrical engineering or computer engineering.
- Familiarity with FPGAs and processors (Xilinx UltraScale+, Zynq, or Versal).
- Capable of administrating a Linux host machine for testing.
- Basic knowledge of RTL and embedded software implementation.
- Familiarity with analog electronics fundamentals (transistor, op-amps, filters, etc).
- Familiarity with DC power supply designs.