Honeywell Advanced Hardware Engr 

India 

409427459

• Design and develop hardware products and systems, end to end product development experience is a must
• Design, define, and simulate analog and digital circuits.
• Conduct FMEAs, Reliability and other failure analysis of HW Design
• Responsible for schematic design , CDR and change management if needed.
• Layout Review and ensure conformance to IPC standards and relevant Honeywell guidelines
• Responsible for new product transfer from R&D to production and provide related technical document.
• Responsible for the hardware circuit problem solving and product design upgrade of the products that have been put into production
• Co-work with local FW/SW/Testing team on system level issues through the project development
• Co-ordinate with regulatory team for product certification
• Co-ordinate with Manufacturing and setup production and test setups
• Chip selection, Hardware debugging, Hardware simulation, Hardware test automation
• Manage BOM and parts Obsolescence and address supply chain issues working with sourcing and factory
• Drive ECN, Disposition Plan, CCB approvals
• Co-work with worldwide hardware team, system team and Customer engineering team on the development status sync up, issue debugging
• Recruit and Mentor Junior Engineer

Skills

• 7 + Years in Schematic Design, Layout Design and Board Bring up
• Experience in Camera Interfaces, Lidar sensors, related filters is an added advantage
• Very Good experience in digital, analogue and mixed signal circuit design
• Strong Product design capabilities from concept to System Architecture
• Design for platform, manage and control BOM for optimal cost
• Board Bring-Up and testing: Including Functional tests, System testing, Compliance to specification, Design Verification
• Test, Power/Timing analysis, Thermal analysis, EMI/EMC tests and SI analysis
• Assist and support CAD team or design team in schematic designs and layout.
• Good experience in EMI/EMC, ESD, FCC testing requirement
• Experience in Power analysis, Power Supply selection, Voltage Regulator and Thermal Analysis.
• Expertise in SMPS, linear power supplier, and OP Amp design
• Should have experience in designing commercial and Industrial product preferably should have worked with MIL grade applications
• Expert level experience in EDA Tools - Mentor Graphics, LT Spice/TINA
• Should have good knowledge of IPC standards for PCB Layout design
• Working knowledge in C and device drivers for broad bring up and design.
• Experience in design using ARM based processors Ti, NXP, ST etc
• Familiar with common bus such as I2C, UART, SPI, RS485, MODBUS, CAN, etc.
• Good analytical skills
• Team player with good communication skills
• Ability to identify and troubleshoot hardware problems including field issue
• Experience in RF design for wireless technologies such as Zigbee, Bluetooth, WIFI products.
• Should be motivated to learn quickly and adapt.
• Familiar with I2C, UART, SPI, RS485, MODBUS, CAN
• Working knowledge in Microsoft tools, Jira or any project management tools
• Working knowledge in code management tools like bit bucket, SVN etc
• Good verbal and written communication skills
• Strong Microsoft Office suite skills – MS Excel/MS Access/Etc.

• Bachelor's degree in Engineering in Electrical /Electronics Engineering
• 10+ years of Industrial experience Product Design

• Some relevant experience
• Deep understanding of a variety of hardware engineering standards and specifications
• Capability to complete demanding assignments by applying advanced hardware engineering methods and tools
• Ability to influence cross-functional teams to deliver optimal solutions
• Ability to consistently make timely decisions and balancing
• Clearly and concisely convey subtle or complex messages to a variety of audiences
• Capability to follow guidelines and ensure efficiency on given project tasks

• JOB ID: HRD239294
• Category: Engineering
• Location: Devarabisanahalli Village, KR Varturhobli,,East Taluk - Phase I,Bangalore,KARNATAKA,560103,India
• Exempt